Short answer
A common guideline is to change the water in a regularly used hot tub about every three to four months. Heavy use calls for more frequent changes. Light or seasonal use can stretch the interval. Tub size, the number of people using it, and how well you maintain the water all affect the right schedule, so treat the numbers below as starting points.
A simple rule of thumb
Many spa guides use this formula:
Tub capacity (gallons) ÷ 3 ÷ average number of bathers per day = days between changes
Example: a 450-gallon tub used by an average of 2 people a day works out to 450 ÷ 3 ÷ 2 = 75 days, or roughly two and a half months. A smaller tub with the same use works out to a shorter interval, because fewer gallons are diluting the same contaminant load.
The formula is only a guide. It does not account for how clean the water is kept, so use the signs below as a reality check.
Typical intervals by use
| How you use the tub | Typical change interval |
|---|---|
| Light, occasional use | Longer, sometimes up to about six months with careful maintenance |
| Regular family use, a few times a week | About every three to four months |
| Heavy or daily use, frequent guests | About monthly, or sooner |
| After a large party | Consider changing soon afterwards |
If you close the tub for a season, many owners drain it before the break and refill when they are ready to use it again, instead of letting old water sit.
Signs you should change the water sooner
- Cloudiness that will not clear after balancing, cleaning the filter and shocking. See how long cloudy hot tub water takes to clear.
- Foam that keeps returning. See foamy hot tub water.
- Odors that are musty, fishy or chemical even though sanitizer tests in range.
- Sanitizer that will not hold, or readings that swing widely.
- Slimy surfaces or a slick feel. See how to tell if you have biofilm in a hot tub.
- Skin irritation or itching after soaking.
- Chemistry that is hard to keep balanced despite following the steps in how to balance hot tub water.
What about TDS?
TDS stands for total dissolved solids: the minerals, sanitizer residue and other dissolved material that builds up as you add chemicals and as water evaporates and is topped up. A TDS meter gives a reading in ppm. Many guides suggest changing the water when TDS has risen by around 1,500 ppm above your starting tap-water reading, though numbers vary by source. High TDS can make sanitizer less effective and can cause cloudiness and foam.
Ways to make water last longer
- Shower before getting in, and keep hair out of the water.
- Rinse swimsuits well, without leaving detergent residue.
- Test the water regularly and keep it balanced.
- Clean the filter on schedule. See how to clean and replace hot tub filters.
- Shock regularly and after heavy use. See how to shock a hot tub.
- Keep the cover on when not in use.
- Consider a plumbing purge before you drain, to clear buildup from the lines.
How to do it
When it is time, follow the steps in how to drain and clean a hot tub. That article covers draining, cleaning the empty shell and refilling. After refilling, rebalance the water before you get in.