Short answer
The most common reasons a hot tub is not circulating are a low water level, a clogged or dirty filter, an air lock in the plumbing, closed valves or jets, debris blocking the intake, or a pump problem. Start with the simple checks first, since most of them cost nothing.
Turn the power off at the breaker before you open equipment compartments or put your hands near the pump. If you suspect an electrical or pump fault, a qualified technician is the safer call.
Start with the easy checks
- Water level. If it is too low, the skimmer can suck air instead of water and flow drops. A commonly recommended level is about midway up the skimmer opening, but check your manual. Top up with a hose if needed.
- Filter. A clogged filter is one of the most frequent causes of weak flow, and often triggers flow-related warnings. Remove it and inspect it. See how to clean and replace hot tub filters.
- Jets and diverter valves. If too many jets are closed, or a diverter is set between positions, flow can drop. Open all the jets and check any air controls.
- Isolation or gate valves. Some spas have valves near the equipment. If someone closed them during service, water cannot circulate. Make sure they are fully open.
- Display or error message. Many spas show codes such as low flow or no flow. Look up the exact code in your manual.
Air lock
After draining and refilling, air can get trapped in the pump or plumbing. The pump may hum, run without moving water, or move very little. Common ways to clear it include:
- Making sure the water level is correct and the filter is seated.
- Turning the power off, loosening the pump union slightly to let trapped air escape, then retightening. (Only do this if your manual covers it, and be careful.)
- Cycling the pump on and off a few times.
If you recently refilled, an air lock is a very plausible cause. See how to drain and clean a hot tub for the refill routine.
Blocked suction or intake
Hair, leaves and other debris can restrict the intake. Check the skimmer basket, intake screens and suction fittings. A wet/dry vacuum can pull debris from the lines. Biofilm and mineral scale can also narrow plumbing over time. See how to tell if you have biofilm.
Pump problems
Signs of a failing pump include:
- Unusual noises such as grinding, whining or loud humming.
- A pump that hums but does not spin, which can point to worn bearings or a seized shaft.
- Water leaking from beneath the pump, which can indicate failed seals.
- Frequent tripping of the breaker.
These are not typical DIY fixes. Switch the power off and call a technician.
Sensors, heater and control faults
Spas use flow switches or pressure sensors to protect the heater. If a sensor is faulty or the heater is scaled up, the system may shut down or report a flow problem even if water is moving. A technician can test the sensors and the control board.
When to call a professional
Call a technician if:
- You have cleaned the filter, checked the water level and valves, and flow is still poor.
- The pump is noisy, leaking or tripping the breaker.
- You see repeated flow-related error codes.
- You are not comfortable working near the electrical parts.
Preventing circulation problems
- Clean the filter on a regular schedule, and keep a spare so you can rotate them.
- Keep the water level where your manual recommends.
- Keep chemistry in range so scale and slime do not form. See how to balance hot tub water.
- Change the water regularly. See how often to change hot tub water.
- Learn how your spa’s plumbing loop works. See how water flows through a hot tub.
Weak circulation also contributes to cloudy water, so it is worth checking if you see cloudy hot tub water that will not clear.