The short answer
For most pools, the water should sit about halfway up the skimmer opening, which is the rectangular mouth in the pool wall. That puts the waterline roughly in the middle of the weir gate’s range of movement. Pool manufacturers and builders may give a slightly different target for a specific skimmer or tile line, so if your pool came with instructions, follow them.
A common range that is often quoted is between about one-third and two-thirds of the way up the opening. Anywhere in that band tends to work, and the middle is the safest place to aim.
Why the level matters
A skimmer is designed to draw water from the surface. For it to work, the water has to be high enough that:
- The pump always has water to draw
- The weir gate can float freely and direct surface water into the basket
- There is a little buffer for evaporation before the level gets dangerously low
If the water level is too low
When the level drops below the bottom of the opening, the skimmer can start pulling air along with water. You may see:
- Gurgling or sucking sounds from the skimmer
- Air bubbles in the pump basket or at the return jets
- The pump losing prime
- Reduced circulation and a cloudier pool
Running a pump with air in it, or without water, can damage the seal and other parts, and over time can burn out the pump. If the water has dropped below the skimmer, turn the pump off and add water first.
If the water level is too high
If the water is above the top of the opening, the weir gate may be submerged and unable to do its job, so skimming gets worse. Debris can stay on the surface instead of being drawn in. A level that is only a little high is usually not harmful, but you may notice that the pool skims poorly. If the pool is much too high after heavy rain, you can lower it by draining some water through your filter’s waste setting or a submersible pump, according to local rules about where the water can go.
Different skimmer types
- Standard skimmers have a rectangular opening that sits partly below the coping, and the target is the middle of that opening.
- Wide-mouth skimmers have a larger opening, and the same general rule applies.
- Above-ground pool skimmers are mounted on the pool wall, and the mid-opening rule also works for them.
- Pools with a tile line or special coping may be designed for the water to sit at a particular spot on the tile. In that case, the tile line is a good guide.
Keeping the level steady
Weather, swimmers and the equipment all change the level:
- Evaporation lowers it, especially in hot, dry or windy weather
- Rain raises it
- Splashing and backwashing remove water
- An automatic water leveler or auto-fill can top the pool up as it drops. If you use one, check it periodically so a stuck valve does not overfill the pool, and know that it can hide a leak
If you are filling by hand, mark the ideal level on the skimmer or tile so you can see at a glance when to add water.
If the level keeps dropping
If you are topping up the pool far more often than the weather would explain, you may have a leak. Start with the bucket test and then read losing water in an inground pool. For where the skimmer sits in the whole circulation loop, see the pool plumbing overview.