Short answer
Turn the pump off, check your valves, and then push water backward through the clogged line from the equipment side using a garden hose with a rag seal or a water-powered drain bladder. Watch the skimmer or drain in the pool for debris to come out, then reassemble and prime the pump. If it does not clear after a couple of careful attempts, a pool professional can use stronger tools such as a line blower.
Before you start
- Turn off the pump at the circuit breaker, not just at a switch.
- Find the clogged line. Most leaf clogs form in the skimmer line, or in a line used for a manual vacuum with the skimmer basket removed. A main drain can also clog. Signs include weak or no suction at one skimmer or at the drain, and the pump basket staying empty while the skimmer is full of debris.
- Check the valves. A closed or partly closed valve, or a faulty diverter, can look like a clog. Make sure the valve on the suspect line is fully open and the valve on the other line is correctly set before you try anything else.
- Clear what you can by hand. Remove the skimmer basket and pick out any debris you can reach in the skimmer throat.
Step by step: backflushing with a hose
This is the method described by pool-supply guides for a blocked skimmer line.
- With the pump off, remove the pump lid and strainer basket.
- Set the valves so that only the clogged suction line is open. This directs all the pressure toward the clog.
- Push a garden hose several inches into the pump’s suction port for that line.
- Pack a wet rag firmly around the hose to plug the opening, without pinching the hose.
- Turn the water on for a few minutes. Have a helper watch the skimmer or drain in the pool to see debris come back out.
- Turn the water off, remove the rag and hose, and reinstall the basket and lid.
- Prime the pump, restart it and check the suction at the skimmer.
If there is little change, you can repeat the process or try a drain bladder.
Using a drain bladder
A drain bladder, such as the Drain King, attaches to the hose and expands inside the pipe to seal it and send pulses of pressure toward the clog. It is generally more effective than a rag because the seal is better. Follow the product’s directions for insertion depth, pipe size and water pressure. Do not use more pressure than the manufacturer recommends, and be aware that old or damaged pipe can be harmed by too much force. Also see our main drain guide, which covers the bladder method for drain lines in more detail.
Compressed air and professional tools
Pool service companies sometimes use line blowers or other equipment to clear stubborn clogs. Some owners use a hand auger, but pool lines often have tight elbows where a rigid tool can get stuck, so use caution. A sewer jetter is generally not a good fit for water-filled pool lines.
If it will not clear
- The clog may be beyond the reach of the water pressure you have
- The line may be crushed, collapsed or separated, which flushing will not fix
- A line that has a leak and a clog can suck in soil or water around the pipe
Persistent loss of suction on one line, especially with water loss, is a reason to call a professional. If the pool is also losing water, see losing water in an inground pool.
Preventing leaf clogs
- Empty the skimmer and pump baskets regularly, especially in autumn
- Do not run the pump with the skimmer basket removed
- If you vacuum manually with a skimmer plate, clear the line afterward
- Skim large debris before it reaches the skimmer after a storm
- Keep a working weir gate in place so debris is not drifting around freely
- Consider a leaf basket or leaf canister on your pump line if you have trees close by
See the pool plumbing overview for how the suction lines connect to the baskets and pump.