What the bucket test tells you
Pools lose water through evaporation even when nothing is wrong. The bucket test compares how much the pool level drops with how much water drops in a bucket sitting in the same pool. The bucket is exposed to the same sun, wind and temperature, but it cannot leak, so any extra drop in the pool beyond the bucket points to a leak (or a drain, such as a leaking pipe).
It does not tell you where the leak is, but it is a quick, inexpensive way to find out whether you need to look for one.
What you need
- A clean 5-gallon bucket
- A permanent marker, or waterproof tape
- A brick or rock to weigh the bucket down, if it floats or tilts
- A ruler or tape measure (optional)
- A day or two with no rain, if possible
Step by step
- Set the pool to its normal level. If you use an auto-fill, turn it off for the test.
- Fill the bucket with pool water to about an inch from the top. Using pool water keeps the temperature similar.
- Place the bucket on a step, about the second step, so that the bucket is partly submerged. Add a rock or brick if needed so it does not tip or float.
- Match the levels. Adjust the water in the bucket until the water level inside matches the pool’s level outside.
- Mark both levels. Draw a line on the inside of the bucket at the water level. Mark the pool’s water level on the outside of the bucket with the marker or tape.
- Turn off the pump and any auto-fill or water feature, as well as anything that adds water. Many guides do the first test with the pump off. Whichever you choose, keep the setup the same for the full test.
- Wait 24 hours. Keep swimmers and pets from splashing or drinking from the bucket.
- Compare the marks. After 24 hours, measure how much the inside water has dropped and how much the outside (pool) level has dropped.
Reading the result
- Both levels dropped by the same amount: the loss is probably evaporation.
- The pool dropped more than the bucket: you most likely have a leak.
- Both dropped a lot: consider weather. Hot, dry or windy conditions can cause surprisingly high evaporation, so repeat the test on a different day.
Estimating how much water you are losing
To estimate the daily loss from a leak, subtract the bucket’s drop from the pool’s drop (in inches), then multiply by the pool’s surface area in square feet and by 0.62 (the number of gallons in one square foot at one inch deep, rounded).
For example, for a 20 ft by 40 ft pool (800 square feet) where the pool dropped 3 inches and the bucket dropped 1 inch:
800 x (3 - 1) x 0.62 = about 992 gallons per day
This is only a rough estimate, since the pool shape and conditions matter, but it helps you see how serious the loss is and how much it may be costing you.
Repeat with the pump running
You can narrow down where the leak is by repeating the test with the pump running, using the same method:
- More loss with the pump on suggests a pressure-side leak, such as a return line
- More loss with the pump off suggests a suction-side leak, such as a skimmer or main drain line
- About the same suggests the leak is in the shell or a fitting in the wall
Since the two tests are done on different days, treat the outcome as a pointer, not proof. For more detail, see losing water in an inground pool.
Common mistakes
- Doing the test during or just before rain
- Letting someone swim or splash during the test
- Putting the bucket where it is out of the sun, or in the shade when the pool is in sun
- Forgetting to turn off the auto-fill
- Not matching the water levels at the start
- Reading the marks from the wrong side
What to do next
If the test shows a leak, check the easy places first: the equipment pad, skimmer and return fittings. For a method of pinpointing the leak in the pool itself, see finding a pool leak with dye. For repairs, see repairing return line leaks and PVC pipe, and for expected costs see is it expensive to fix a pool leak.