The short answer
Most pool plumbing is rigid PVC pipe, usually Schedule 40, joined with PVC primer and solvent cement. In some regions, especially colder ones, flexible PVC (often called flex pipe) is also used for underground runs. Equipment pads are generally plumbed in rigid pipe.
Rigid PVC: Schedule 40 and Schedule 80
PVC pipe is sold in “schedules” that describe wall thickness:
- Schedule 40 is the standard for residential pool plumbing. It has a smooth interior, a high pressure rating compared with the pressures pools use, and a wide range of fittings.
- Schedule 80 has thicker walls and is used where more strength is needed, for example in some commercial or specialised installations. It costs more and uses different fittings in places.
- Thin-wall pipe, such as Schedule 20 sometimes used for conduit or light-duty drainage, should not be used for pool or spa plumbing.
Pool systems normally run at modest pressures, far below what rigid Schedule 40 can handle, but plumbing should still be built for hammer, heat and years of use.
Flexible PVC
Flexible PVC is technically a hose rather than a rigid pipe. It comes in rolls, which makes it easy to carry and to lay in a trench, and it is more forgiving in tight spots. Its main advantage is in cold climates. It resists cracking when the ground freezes and thaws or when water inside freezes, so many pools in colder areas are plumbed with it.
The trade-offs:
- A lower pressure rating than rigid pipe
- A ribbed or rough interior that adds friction compared with smooth rigid pipe
- Less UV resistance, so it should not be left exposed to sun
- Joints between flex pipe and rigid fittings can be weaker over time, especially where there is pressure surging or heavy flow
- It can crush or kink if poorly bedded, and in some regions pests may chew through it
Some builders in cold climates have used flex pipe for decades with good results, so it is not automatically a problem. But where there is no freezing, many professionals prefer all-rigid plumbing.
Rigid vs flexible: where each makes sense
- Equipment pad and above-ground runs: rigid
- Underground runs in mild climates: typically rigid
- Underground runs in freezing climates: rigid with careful bedding and depth, or flexible, depending on the installer’s experience and local practice
- Spa jet lines: commonly rigid, since surging flow is hard on flex connections
Local building practice and codes vary. When in doubt, ask a local pool builder what has worked in your area.
Pipe sizes
Pipe is named by nominal size, not by exact measured diameter. Many residential pools use 1.5-inch or 2-inch pipe for suction and return lines, with 2-inch and larger sizes common on bigger systems. Fittings must match the pipe type and size. When replacing a section, take a piece of the old pipe to the store, since mixing sizes and types is a frequent cause of leaks. As one forum helper noted, people often run into pipe-size mismatches during repairs.
Joining pipe: primer and cement
Rigid PVC is normally joined by solvent welding:
- Cut the pipe square and remove burrs, and chamfer the outer edge slightly
- Dry-fit the parts
- Apply primer to the pipe end and the inside of the fitting
- Apply cement, push the pieces together with a slight twist, and hold briefly
- Allow the cement to cure fully before pressurising
Use a primer and cement that are rated for the pipe type and size. Threaded connections, such as those into pumps, filters or valves, are sealed with thread tape or thread sealant meant for plastic fittings. For a full repair procedure, see repairing return line leaks and PVC pipe.
Pipes that are not PVC
Older or specialised pools may include other materials, such as copper in heater connections or ABS in some regions, or flexible spa tubing inside a spa. If you are not sure what you have, ask a professional before cutting or gluing. Never mix solvent cements across different plastics.
For where each pipe sits in the circuit, see the pool plumbing system overview.