The short answer
Cloudy pool water is usually caused by one or more of these: low or ineffective chlorine, unbalanced pH, alkalinity or calcium hardness, a filter that is dirty or not running long enough, early algae growth, or fine debris that the filter cannot catch. Cloudiness right after shocking can also be normal and often clears as the filter works.
The fastest way to find which one applies is to test the water before adding anything.
Start with a test
Check these readings, using a reliable liquid kit if you can:
- Free and total chlorine
- pH
- Total alkalinity
- Calcium hardness
- Cyanuric acid (CYA)
Then look at the filter pressure gauge, the pump run time and the water itself. A slight greenish tint points toward algae. A white or milky haze points more toward chemistry or fine particles.
Common causes
Low chlorine. Without enough free chlorine, bacteria, organic waste and early algae build up and the water turns hazy. Check that your chlorine level suits your CYA. See the ideal CYA level and matching chlorine level. High CYA makes chlorine less effective even when the reading looks normal.
High combined chlorine. If total chlorine is well above free chlorine, much of your chlorine is tied up. See free, total and combined chlorine.
High pH or alkalinity. At higher pH, chlorine works less well and calcium can fall out of solution, turning water milky. See the pool pH guide and how to lower the alkalinity in your pool.
High calcium hardness. Hard fill water can cause scale and cloudiness, especially at high pH. See calcium hardness for ranges. Low hardness can also contribute in plaster pools.
Poor filtration or circulation. A dirty filter, blocked skimmer basket, or a pump that runs too few hours leaves fine particles in the water. Many sources suggest running a pump at least 8-12 hours a day in swimming season, longer while clearing a problem.
Early algae. A dull, hazy, faintly green cast often signals an algae bloom starting. Brush surfaces and raise chlorine appropriately.
Fine debris and swimmer contaminants. Pollen, dust, sunscreen, body oils and rainwater can all cloud water. Heavy use and storms make it worse.
After shocking. The water may look cloudy for a while because dead contaminants are suspended in it. Keep the filter running and clean it when pressure rises.
How to clear it
- Clean the filter. Backwash a sand or DE filter, or rinse a cartridge filter, as your equipment manual describes.
- Remove debris and brush walls and floor.
- Balance the chemistry in this order: alkalinity, pH, then chlorine. Make changes in small steps and retest.
- Raise chlorine if needed. To work out a dose, see how much chlorine to add to your pool. Check how shocking affects pH too.
- Run the pump longer, often continuously, until the water clears.
- Retest every day or two and adjust.
Clarifier or flocculant
If chemistry and filtration are in order but the water stays hazy, a product may help:
- Clarifier clumps tiny particles so the filter can trap them. It is slower and gentle.
- Flocculant makes particles sink to the floor so you can vacuum them to waste. It is faster but needs manual vacuuming and the filter bypassed.
Overdosing either can make the water worse, so follow the label. A clarifier does not fix a chemistry or sanitizer problem, so correct those first.
Preventing it
Test weekly, keep chlorine and pH in range, clean the filter on a schedule, skim and brush regularly and cover the pool when not in use. A log of your readings helps catch trends early. For the full set of basics, see pool water chemistry for beginners.