The short answer
Total alkalinity (TA) is lowered with acid: either liquid muriatic acid or granular dry acid (sodium bisulfate). Add it in small doses with the pump running, retest after the water has circulated, and repeat until TA is in range. Because acid also lowers pH, many owners then aerate the water to raise pH back up without raising TA again.
Target range and why it matters
A commonly used target for total alkalinity is about 80-120 ppm, and some local codes or pool types allow somewhat wider ranges. TA is the pool’s pH buffer. When it is too high, pH tends to drift upward and is hard to bring down, and the water can scale or turn cloudy. Too low, and pH swings widely.
Test TA with a drop kit if you can, since strips are less exact. If you are not sure of your pH, check it too. See how to raise and lower pool pH.
What you need
- A reliable test kit
- Muriatic acid or dry acid designed for pools
- A clean, acid-resistant bucket, plus gloves, goggles and ventilation
- A way to aerate, such as upward-pointing return jets, a fountain or a waterfall feature
Method: acid, then aerate
- Test TA and pH. Know your starting numbers and your pool volume.
- Run the pump so the acid mixes through the water.
- Work out a first dose. Use the product label or a pool calculator. As a rough guide from the chemistry, about 25 fluid ounces of 31.45% muriatic acid per 10,000 gallons lowers TA by about 10 ppm. Many guides suggest only reducing TA by around 10-20 ppm at a time, so start well short of the full dose.
- Dilute and add safely. If the label calls for dilution, put water in the bucket first and add acid to it, never the reverse. Pour slowly around the deep end or the perimeter, away from metal ladders and lights.
- Let pH fall. Acid lowers pH along with TA. Many owners let pH drop toward about 7.0-7.2 (not lower) while working.
- Aerate. Turn return jets upward, or run a fountain or waterfall. This releases carbon dioxide and raises pH without raising TA.
- Wait and retest. Give it several hours or overnight, then test TA and pH again.
- Repeat in small steps until TA is in range. If pH drifts below your range, raise it with soda ash and retest.
How much acid
Use your actual pool volume and the product’s strength, because 31.45% muriatic acid, weaker pool-store acid and dry acid all differ. Overdosing can push pH too low, which damages surfaces and equipment and irritates swimmers. Splitting a large correction over several days is normal.
Safety
- Wear chemical-resistant gloves, eye protection and closed clothing.
- Work in open air and do not breathe fumes.
- Never mix acid with chlorine or other chemicals. This can release toxic gas.
- Add acid to water, never water to acid.
- Keep children and pets away and store in the original container.
- Wait for the water to circulate and for pH to be back in range before swimming.
Why alkalinity creeps up
TA rises when you add chemicals that carry alkalinity. These include calcium hypochlorite, liquid chlorine to a smaller extent, and baking soda or soda ash. Fill water high in alkalinity does the same. Evaporation concentrates what is left. If you add products regularly, check whether they are pushing TA up. Related questions about shock chemistry are covered in does shocking a pool raise pH. If high TA is making water hazy, see why pool water goes cloudy.
For the full picture of how TA fits with other readings, see pool water chemistry for beginners.