The three numbers
A good chlorine test, usually a DPD test, can report two readings, and the third comes from simple subtraction:
- Free chlorine (FC): chlorine that is still available to sanitize. This is the number that matters most day to day.
- Combined chlorine (CC): chlorine that has already reacted with contaminants such as sweat, urine and body oils, forming compounds called chloramines. It is weakly sanitizing and a cause of irritation and odor.
- Total chlorine (TC): free plus combined.
The formula
Combined chlorine = total chlorine − free chlorine
Example: your kit reads FC 3.0 ppm and TC 3.4 ppm. Combined chlorine is 0.4 ppm.
Why combined chlorine matters
The pool smell people associate with “too much chlorine” is more often combined chlorine, not high free chlorine. A pool with strong odor and red eyes may actually be short on free chlorine, because it has been consumed by contaminants.
A commonly used guideline is to keep combined chlorine low, often under about 0.5 ppm and ideally close to zero. Public pool rules often set a specific maximum, such as 0.4 ppm. If it climbs above that, the pool usually needs a treatment to break the chloramines down.
For target free chlorine levels, see how much chlorine to add to your pool. Free chlorine needs also depend on CYA, as covered in the ideal CYA level and the chlorine level that goes with it.
Reading free and total together
| Free chlorine | Total chlorine | Combined chlorine | What it suggests |
|---|---|---|---|
| Adequate | About the same as free | Near zero | Healthy. Keep maintaining. |
| Low | Low | Low | Not enough chlorine. Add more. |
| Low | High | High | Contaminants have used up chlorine. Treat for chloramines. |
| High | High | High | You may have overdosed, and there is also combined chlorine to deal with. |
Looking at only one number can mislead. A low free reading does not tell you whether you simply under-dosed or whether contaminants are consuming chlorine. A normal total reading can hide a pool where almost all chlorine is combined.
What to do about high combined chlorine
A widely used method is breakpoint chlorination: raise free chlorine well above the combined level so it can break the chloramines apart. A common rule of thumb is to bring free chlorine to about 10 times the combined chlorine reading. Pools with more CYA need a higher free chlorine level to do this, so many owners follow a shock level tied to their CYA. Some people use non-chlorine shock for routine oxidizing, though it does not raise free chlorine.
Practical steps:
- Test FC, TC, pH and CYA. Calculate combined chlorine.
- Fix pH first if it is high. See how to raise and lower pool pH.
- Dose chlorine to the target level for your pool. See how much chlorine to add.
- Keep the pump running and keep swimmers out until chlorine falls back to a safe range. See is a chlorine level of 10 safe.
- Retest and repeat if combined chlorine remains.
Preventing chloramines is easier than fixing them: encourage showers before swimming, keep pets and food out of the pool, and keep free chlorine consistent.
Testing tips
- Use a DPD-based kit that reports both free and total chlorine. Many test strips give only a rough total or free number, so check what yours measures.
- Read promptly. DPD results can change color with time, so follow your kit’s timing.
- Very high chlorine can bleach the reagent so that a pool full of chlorine appears to read zero. If a reading seems wrong, dilute the sample as your kit instructs and retest.
- Test before and after shocking to see what changed.
- Always follow your kit’s instructions. Reagents expire.
Pools that never seem to hold a reading may have a test or a demand problem. See chlorine tablets, dichlor and why a pool won’t hold chlorine.
For the basics behind all these numbers, see pool water chemistry for beginners.