The short answer
A free chlorine reading of 10 ppm is well above a normal swimming level. It is not usually an emergency, but it is higher than most people should swim in. Wait until it falls closer to the normal range before swimming, especially with children or anyone who has asthma or sensitive skin. If you are unsure, err on the side of waiting.
What counts as a normal level
Typical free chlorine targets for residential pools are around 1-3 ppm. The CDC lists a 1 ppm minimum for pools, and 2 ppm when the pool contains stabilizer. Higher CYA means you need more free chlorine to get the same sanitizing effect, as covered in the ideal CYA level and the matching chlorine level. Public pool codes vary and often set both minimum and maximum levels, so a home pool is not governed by the same rules but the principle is similar.
For the three chlorine numbers on your test, see free, total and combined chlorine.
Is 5, 7 or 10 ppm too high?
- About 5 ppm: Above ordinary maintenance. Many guides suggest avoiding long swims until it drops.
- About 7 ppm: Common during shocking. It is higher than needed for routine swimming.
- 10 ppm and above: Typical of an intentional shock level, or an overdose.
Mild effects at high levels can include stinging eyes, dry skin, a strong smell and bleaching of swimwear or liners. These effects are stronger if pH is off. If anyone has breathing difficulty, keep them out of the water and away from fumes.
When 10 ppm is intentional
Shock levels are often 5-10 ppm or higher, and some approaches, such as high-level shock when treating algae, hold chlorine even higher for a time. In those cases, the pool is not for swimming until the level drops. How high is appropriate depends strongly on the pool’s CYA. A pool with CYA around 50-80 ppm needs a much higher level to be effective than one with CYA at 20 ppm. That is part of why you cannot judge a reading without the stabilizer reading.
Why CYA changes the picture
CYA binds part of the free chlorine, which makes it less aggressive and less active. So 10 ppm of free chlorine in a pool with high CYA is less harsh than 10 ppm without CYA. That is a reason some experienced owners are comfortable at higher numbers. For a general reader, though, the cautious approach is to wait until the level is down in the normal range, since you cannot easily judge comfort or safety from the number alone.
What to do if it is higher than you meant
- Stop adding chlorine and remove any tablets from the feeder or floater.
- Keep swimmers out until the reading drops.
- Let it fall naturally. Sunlight and normal use consume chlorine. Leaving the pool uncovered in daylight and running the pump speeds this up.
- Retest every few hours, then daily, until it is in range.
- Consider a neutralizer only if you need to swim sooner. Products based on sodium thiosulfate exist. Follow the label, avoid overdosing, and retest afterward.
- Check pH. Water with pH well out of range feels harsher. See how to raise and lower pool pH.
If your chlorine is high because of a mistake in dosing, how much chlorine to add to your pool can help you avoid repeating it.
Check the reading
Make sure it is real before acting. Test strips and some drop kits max out or behave oddly at very high levels. Retest with fresh reagents and dilute the sample with clean water if your kit says to. Use a kit that reports free chlorine rather than only total chlorine.
Who should be extra cautious
Young children, people with asthma or other breathing problems, and anyone with skin conditions may react at lower levels than others. If someone feels unwell after swimming, get medical advice. Never mix chlorine with other chemicals, because this can create harmful gases.
For the basics of sanitizer levels, see pool water chemistry for beginners.