Saltwater Pools

How Much Salt to Add to a Pool: Pounds Needed by Gallon and Target ppm

Work out how much salt to add to a pool with a simple formula, a table of pounds by gallons, and a worked example based on your current and target ppm.

On this page
  1. The quick answer
  2. The formula
  3. Pounds needed from zero to 3,200 ppm
  4. A worked example
  5. Working out your pool volume
  6. How to add the salt
  7. Tips

The quick answer

To raise a pool from zero salt to a common target of about 3,200 ppm, you need roughly 267 pounds of salt per 10,000 gallons, or between six and seven 40-pound bags. If your pool already has some salt, you only add the difference between your current reading and your target. Always check your generator’s manual for its recommended target, since it varies by model.

The formula

Water weighs about 8.34 pounds per gallon, which gives a simple relationship:

Pounds of salt = pool gallons × 8.34 × (target ppm − current ppm) ÷ 1,000,000

You can sanity-check it with the salt bag. A 40-pound bag in a 10,000 gallon pool works out to about 480 ppm, which matches the figures printed on many bags.

Pounds needed from zero to 3,200 ppm

Pool volume Pounds of salt (approx.) 40 lb bags (approx.)
5,000 gallons 133 3.3
10,000 gallons 267 6.7
15,000 gallons 400 10
20,000 gallons 534 13.4
30,000 gallons 800 20

These are starting points. If your target is different, rework the formula with your number. A target of 3,500 ppm, for instance, needs about 292 pounds per 10,000 gallons.

A worked example

Your pool holds 15,000 gallons. The generator’s manual recommends 3,200 ppm, and your salt test reads 1,200 ppm after a heavy rain.

  1. Difference: 3,200 − 1,200 = 2,000 ppm.
  2. Pounds: 15,000 × 8.34 × 2,000 ÷ 1,000,000 = about 250 pounds.
  3. Bags: 250 ÷ 40 is a little over six bags.

Many owners add a bit less than the full amount, let it dissolve, retest, and top up. This avoids overshooting. See is 4000 ppm salt too high if you do.

Working out your pool volume

The formula is only as accurate as your volume estimate. For a rectangular pool, a common approximation is length × width × average depth × 7.5 gallons per cubic foot. Round or oval pools use different shortcuts, so check the manufacturer’s stated capacity where you can. An inaccurate volume is one of the most common causes of ending up with too much or too little salt. If the volume is uncertain, add conservatively and retest.

How to add the salt

  1. Test the current salt level using a salt meter or reliable test, not only the generator’s readout.
  2. Turn the generator off, and keep the pump and filter running.
  3. Pour pool-grade salt around the perimeter, avoiding piles in one place. Brush it so it dissolves faster. Do not dump it into the skimmer.
  4. Run the pump for about 24 hours, then retest before turning the generator on or adding more.

For choosing a product, see what is the best salt for your pool.

Tips

The complete guide to saltwater pools

Saltwater Pool Care: Salt, pH and Shock
Read the guide

Keep exploring

Guides from other topics

All topics →