Saltwater Pools

Is 4000 ppm salt too high for a pool?

Is 4000 ppm salt too high for a pool? It depends on your generator. Learn how to confirm the reading and how to lower it by partial draining and refilling.

On this page
  1. The short answer
  2. Why levels end up high
  3. Check the reading first
  4. How to lower it
  5. Preventing it

The short answer

It depends on your generator. Many salt chlorine generators are designed around a target somewhere in the low-to-mid 3,000 ppm range, and some tolerate readings of 4,000 ppm or more. Others warn or reduce output when salt is above their upper limit. Check the manual for the recommended range of your model. If 4000 ppm is inside that range, you can usually leave it. If it is above, it makes sense to bring it down.

High salt is generally less urgent than low salt, which stops chlorine production. But very high salt can make the water more corrosive to metal parts and can trigger high-salt warnings on some controllers.

Why levels end up high

The most common reason is adding salt based on the wrong pool volume. If a pool is smaller than you assumed, the same amount of salt produces a higher concentration. Adding salt again before the earlier dose has fully dissolved and circulated, or testing before the salt has mixed, can also lead to misleading readings. Evaporation does not help: water evaporates but the salt stays behind, so the concentration actually rises slightly as water is lost.

Check the reading first

Before draining anything, confirm the number. Test strips and the readout on a generator can be imprecise, so check with a second method such as a digital salt meter or a pool store test. Make sure the pump has been running for a day or so since you last added salt so the water is mixed. If the readings agree and are above your manufacturer’s range, dilute.

How to lower it

The only practical way to reduce salt is to replace some pool water with fresh water. Use this approach:

  1. Work out the fraction to replace: (measured ppm minus target ppm) divided by measured ppm.
  2. Convert to depth: multiply that fraction by your pool’s average depth.
  3. Drain that depth and refill with fresh water, then wait for it to circulate and retest.

Example: the reading is 4,000 ppm and the target is 3,500 ppm. The fraction is 500 divided by 4,000, which is 12.5 percent, or one eighth. If the pool’s average depth is 4.5 feet, or 54 inches, one eighth is about 6.75 inches. You would drain roughly 7 inches and refill. Because pools vary in shape, treat this as an estimate, retest, and repeat if needed. Follow local rules about where you may discharge pool water, and avoid draining so low that you put the liner or structure at risk. If you have a vinyl liner, a fiberglass shell or a high water table, check your pool’s guidance before lowering the level significantly.

Preventing it

Measure or calculate your volume carefully, then add salt in stages and retest. Our guide to how much salt to add to a pool gives the formula. For more on salt and how it affects your pool, see our saltwater pool care guide. If chlorine output seems off at your current salt level, see salt chlorinator not producing chlorine.

The complete guide to saltwater pools

Saltwater Pool Care: Salt, pH and Shock
Read the guide

Keep exploring

Guides from other topics

All topics →