Short answer
There is no single best option, because it depends on the type of pool and the ground you have. In general, the base should be cleared, firm and level, with a protective layer between the ground and the liner. For many soft-sided pools, that is a ground cloth plus foam tiles or a pool pad. For many framed pools, builders often use a compacted layer of sand, sometimes with a foam or geotextile pad on top, and supports under the legs. Always check what the pool’s manufacturer recommends, since it can affect the warranty.
First, prepare the ground
No material underneath can make up for poor preparation.
- Check for buried utilities before digging or leveling.
- Remove sod, roots, rocks and debris. Grass and roots can decay and leave hollows or push up through the liner.
- Level by cutting, not filling. Digging down the high side is generally more stable than adding loose soil to the low side, which can settle under the weight of the water. If the ground is badly out of level, see how to level an above ground pool.
- Compact the soil so the base is firm. A soft spot is where divots can start.
Common base options
Ground cloth or tarp. Soft-sided pools often come with a ground cloth. It provides basic protection from small debris, but it is thin, and it will not smooth over a rough or uneven surface.
Foam tiles or pool pads. Interlocking foam tiles or pre-cut pads add cushioning and a barrier against small stones and roots. They are popular for soft-sided and framed pools. Look for ones sold for pool use.
Geotextile or non-woven pads. Heavy-duty fabric pads offer puncture protection and can help with weed growth, though you still need a smooth base.
Sand. Many builders use masonry or mason sand, a fine sand without stones, spread in a layer of an inch or two and compacted. It gives a smooth, firm bed, though it can wash out if water gets under the pool. Do not use coarse or sharp sand, gravel or crushed stone, which can damage the liner. Follow the pool’s instructions on thickness and whether sand is recommended.
Rubber stall mats. Some owners lay rubber horse stall mats for durability and cushioning. They are heavy and add cost, and need a flat base, but they resist roots and decay.
Vermiculite and cement mix. Some installers use a troweled mix of vermiculite and Portland cement for a firm, smooth, slightly cushioned permanent floor. It is a more involved job and permanent, so it usually suits long-term, framed installations. Ask an experienced installer.
Soft-sided versus framed pools
- Soft-sided and inflatable-ring pools usually only need a smooth, level, cleared surface with a ground cloth and perhaps foam tiles. Sand is often not required and can shift if the pool is moved. See our Intex setup guide for more.
- Framed or steel wall pools carry a lot of weight on their wall and legs. They benefit from a well-compacted base and a smooth bottom layer, and the manufacturer’s installation manual usually gives specific requirements.
Supporting the legs
Metal-frame pools concentrate weight at each upright. Many owners place solid pavers or leg plates under each leg so they do not sink. Make sure the supports are level with each other, since uneven legs can put the frame out of true. Use solid, flat concrete pavers or plates rather than crumbling materials.
What to avoid
- Setting up on unprepared grass or soil.
- Building up low spots with loose dirt.
- Using gravel, crushed stone or anything with sharp edges.
- Using wood, which can rot and attract insects.
- Putting a pool on a slope, or on ground that stays wet.
- Using thick padding that squishes unevenly, or mixing materials in ways that create an uneven surface.
Drainage and weeds
Water that gets beneath the pool can wash out sand and cause settling, so think about where rainwater will run. Some owners treat the area for weeds before laying the base, but check any product is safe for pool use and follow the label. Over time, a poor base can cause divots and bubbles in the liner, and a well-prepared base can help the pool last longer; see how long above ground pools last.